☎ 09178842345 ✉ Email Us
MUC-OFF BIKE ULTIMATE TUBELESS SETUP KIT
MUC-OFF BIKE ULTIMATE TUBELESS SETUP KIT - ROAD / 44MM is backordered and will ship as soon as it is back in stock.
Pickup available at Motoworld E-commerce Warehouse
Usually ready in 2-4 days
Delivery and Shipping
Delivery and Shipping
Delivery is limited to addresses within the Philippines. The customer is responsible for providing the correct and complete delivery details:
Description
Description
The Muc-Off Ultimate Tubeless Kit contains everything needed to get a tubeless-ready wheelset set up and ready to roll. Each Kit contains a Muc-Off Tubeless Rim Tape, Seal Patches, 2 CNC-machined black tubeless Valves and 2 pouches of No Puncture Hassle Tubeless Sealant.
Our kit options:
- Road (21MM TAPE / 44MM VALVES)
- Road (21MM TAPE / 60MM VALVES)
- XC/Gravel (25MM TAPE / 44MM VALVES)
- DH/Trail/Enduro (30MM TAPE / 44MM VALVES)
- DH/PLUS (35MM TAPE / 44MM VALVES)
HOW TO USE
- Remove all old rim strips or tape and clean the rim.
- Make sure the rim is clean and dry before applying tape.
- Get the tape from the packet and line it up from the opposite side of the valve.
- Start by unwinding a small amount of the tape and pressing it down using your thumb or finger to hold the pressure down.
- Continue to hold while you pull back on the tape and stick down tight once you have a few cm on the tape will stick and holding is no longer needed.
- Continue the entire way around the rim (if it has a big concave in you can pull and wiggle the tape to fill any edges)
- Overlap the tape by roughly 10 – 15cm
- Leave a small amount unstuck so that you can cut the remainder off
- Once cut sketch and pull the tape down to create a seal
- Go around the rim with your thumb to make sure there is no air pockets or messed areas.
- Once you are happy with how it looks using a small pin locate the valve hole and cleanly pierce the tape ready for the valve
- Grab your tubeless valve and remove the lock ring and o ring
- Chose the right rubber fitment for your rim tape and insert the valve into the rim
- Refit the O-ring and Lock ring making sure you lock the valve in (don’t go to tight or it could damage the rubber)
- Re-fit your tyre of choice careful not to damage the tape (by using tyre levers etc.)
- Inflate tire to create a fit (you should hear some popping around the rim)
- Release the Air and remove valve core using the spare valve cap
- Grab the sealant pouch and give it a shake
- Unscrew the cap and fit on the valve in an upright position
- While holding the pouch spin the wheel downward so that the pouch is now upside down
- Insert the sealant by rolling the pouch down
- Spin the wheel back upright and remove the pouch
- Reinsert the valve core and inflate to your pressure